Operational Amplifiers

Trimming at the wafer stage results in a very low input offset voltage (75 V maximum for OP07E). These low offset voltages obviate the requirement for external nulling in most cases. The OP07 also has...

The NE5532 operational amplifiers are high-performance devices with good DC and AC characteristics. Low noise, high output drive capacity, high unity-gain, and maximum-output-swing bandwidths, low distortion, high slew rate, input-protection diodes, and output short-circuit protection...

The 741 series is a general-purpose operational amplifier that outperforms industry standards such as the LM709. In most cases, they are direct, Exceeded plug-in replacements for the 709C, LM201, MC1439, and 748. Many aspects of...

The LM386 is power amplifier designed for use in low voltage consumer applications. The gain is internally set to 20 to keep external part count low, but the addition of an external resistor and capacitor...

These devices are made up of four separate high-gain frequency-compensated operational amplifiers that are meant to operate from a single power source across a wide voltage range. Split-supply operation is also allowed if the voltage...

This Dual Channel Stereo Class D Amplifier Board is intended to drive bridged-tied stereo speakers and is built as a 15W (per channel). This Amplifier Board is typically used with 8-ohm speakers, although it can...

The LM358 is a dual op-amp IC that integrates two op-amps that are powered by a single power supply. It is one half of the LM324 Quad op-amp, which contains four op-amps with a shared...

This amplifier module is based on the LM358 operational amplifier, which is a high-gain, frequency adjusted operational amplifier designed to operate across a wide voltage range from a single power source. It is utilised in...